|
Wasps
DESCRIPTION
Order: Hymenoptera (‘membrane winged’)
Characteristics:
Up to 30mm long; eyes kidney shaped; two pairs of membranous wings, the
hind wings smaller than the forewings and linked to them by a row of hooklets;
wings folded longitudinally at rest; mouthparts adapted for chewing and
licking; dorsal surface of the first thoracic segment extends back to
a small lobe which overlies the base of the front wing; abdomen constricted
at base giving appearance of a waist; metamorphosis complete, with egg,
larval, pupal and adult stages; typically possess complex social system
(sub-family Vespinae).
Family: Vespidae
Species Characteristics:
Genus: Vespula and Vespa.Similar in appearance.
Distinguished by patterns on the face and abdomen. The following species
are found in Northern Europe:
Common Wasp (Vespula (Paravespula) vulgaris)
Nests underground and in cavities in trees and buildings.
German Wasp (Vespula (Paravespula) germanica)
Nests underground and in cavities in trees and buildings.
Tree Wasp (Vespula (Dolichovespula) sylvestris)
Nests suspended from the branches of trees or constructed underground.
Norwegian Wasp (Vespula (Dolichovespula) norvegica)
Constructs small nests on twigs e.g. on gooseberry bushes and hawthorn.
Cuckoo Wasp (Vespula austriaca)
Worker caste lacking. It is parasitic usually laying its eggs in the nests
of the Red Wasp.
Red Wasp (Vespula rufa)
Nests underground.
Hornet (Vespa crabro)
The largest of the wasps but relatively uncommon. Nests in hollow trees
and occasionally buildings.
Genus: Odynerus, Mason wasps.
Solitary wasps about 13mm long predominantly black with yellow markings.
The females construct nests of a few cells each of which contain an egg
and is provisioned with food e.g. caterpillars. The larvae which hatch
from the eggs feed themselves and live independently from their neighbours.
Nests will be constructed in the ground and in soft mortar.
SIGNIFICANCE
Wasps can be regarded as beneficial insects. As the nests develop during
the spring and early summer the workers collect insect larvae, scraps
of meat and even fish to feed to larvae. They therefore help to control
insect pests and clear carcasses. The workers prefer high energy carbohydrates
which they obtain from fruits and the nectar of flowers. They could act
as pollinators although are unlikely to be as efficient as honey bees.
In general, however, wasps are regarded as nuisance pests or a threat
to health. They feed on fruits e.g. apples, pears and plums although they
are regarded as scavengers extending the damage caused by other pests
and diseases. The need to collect wood to construct nests means that wasps
may damage the wooden fabric of buildings, fences and even perhaps garden
furniture.
Wasps are a particular nuisance at the end of the summer when the workers
are freed of the need to collect proteinaceous foods for their young and
can indulge their passion for sweet materials e.g. jam and syrup. They
cause a nuisance when they enter kitchens, bakeries and other premises
handling sweet aromatic materials. Foodstuffs can be contaminated and
staff will be disturbed or even stung. Where wasp densities are high and
a real threat is perceived, production in workplaces can be halted.
It is the ability of wasps to cause painful stings that concerns most
people. Unexplained road accidents have sometimes been attributed to the
distraction of drivers by wasps. They are not regarded as particularly
aggressive and the ability to sting is employed by the social wasps to
defend their nests.
The sting is caused by the injection of venom into the victim by means
of the modified ovipositor of the females. Unlike the sting of bees the
wasp sting can be withdrawn from the victim. The venom is haemolytic,
haemorrhagic and neurotoxic. Histamine is also present which causes the
redness, flare and weal in skin.
Wasp stings around the throat may lead to respiratory obstruction. Alternatively
they may be directly toxic causing faintness, respiratory difficulty,
vomiting, diarrhoea and perhaps urticaria. These are only likely to appear
following a mass attack. The main hazard is the risk of anaphylactic shock
arising from repeated stings or even a single one which may lead to death.
Symptoms may appear rapidly and include respiratory distress, faintness,
an itching rash, swelling of the face and vomiting with abdominal pain,
cramp or diarrhoea. Medical assistance should be sought where anaphylactic
shock is suspected.
Stings can be treated with a cold compress and antihistamine creams applied
within twenty minutes of stinging. A suitable antiseptic cream should
also be rubbed into the skin to prevent infection.
LIFE-CYCLE
Wasps are typically social insects with new nests constructed each year.
The queens, which are larger than the workers, overwinter in harbourages
in buildings, under loose bark or even in old nests. They emerge in the
spring and will feed on nectar and sap. Nests are located underground,
in buildings, trees or bushes and constructed of wasp paper made by chewing
wood and other plant debris with saliva. First a canopy is fixed to the
top of the nest location and then a central pedicel from which the nest
is suspended. The queen then builds a layer of hexagonal downward-facing
cells radially from the pedicel. Layers of wasp paper envelop the nest
providing protection from the elements and conserving heat.
Eggs are laid in the first tier of the nest built by the queen. They are
cemented into place and the emerging larvae, which hatch in a few days
depending upon temperature, only partially emerge in order to stop them
falling from the cells. The fully grown larvae construct silken cocoons
and seal themselves into the cells in order to pupate. Four to six weeks
after the eggs are laid the first generation workers emerge. These are
female wasps but smaller than the queens and males which emerge later
in the season. The workers then take responsibility for maintaining the
nest. They extend it by adding further radial layers of cells suspended
by wasp paper stalks below the first tier. In this way up to eight tiers
may be constructed and the whole enveloped in wasp paper with the entrance
at the bottom. If the nest overheats the workers ventilate it by vibrating
their wings or even by introducing water droplets which cool it by evaporating.
The workers also forage for food and in particular high protein foodstuffs
for the larvae e.g. flies, caterpillars, spiders etc. In their turn the
larvae exude a secretion which contains sugar and proteases. This is taken
by the workers and provides a useful food supplement whilst also helping
them to break down the proteinaceous foods destined for the larvae. This
is trophallaxis a relationship in which both parties gain and which probably
helps to ensure the workers allegiance to the nest.
As the workers develop the nest the queen devotes her time to egg laying.
Each cell may be employed several times to rear larvae and by the end
of the summer the nest may contain 20,000 or more wasps.
In the autumn, new queens and males are produced. The latter fertilize
the queens who then search for hibernation sites. With the onset of severe
weather the nests die out.
CONTROL
Measures to control wasps can be directed at the foraging wasps or their
nests.
Foraging wasp control
a) Hygiene/management
Foraging wasps can be excluded from buildings by the use of 3mm screens.
Bait traps may be of value on a limited scale.
b) Insecticidal control
Space sprays:
Large or small scale (e.g. hand held aerosols) space sprays can be used
indoors to knockdown and kill flying wasps. Operators should take care
to avoid being stung by intoxicated wasps.
Surface sprays:
The application of a residual film of insecticide can assist wasp control
in localised areas e.g. around syrup intake points.
Wasp nest control using insecticides
Nests can be located by searching likely sites on fine days for signs
of wasp activity. Flight lines of foraging wasps converging towards, or
diverging away from nests may be observed in order to pin-point the nests.
Ideally nests should only be treated with insecticides when activity around
the nest is quiet.
Operators should wear suitable protective clothing including a veil, gloves
and tight fitting sleeves and trouser cuffs. Other people should be kept
away.
Nests can then be treated by:
Powder treatment:
An insecticidal powder can be applied around and into the entrance of
the nest. Workers are contaminated when they return to the nest and carry
the powder inside. Powders are applied using mechanical dusters which
may be equipped with extension tubes, a spoon (which can be attached to
a cane) or a suitably labelled proprietary puffer pack.
Surface spraying:
A liquid surface spray may be applied liberally and directly to the nest
or to the entrance holes of concealed nests.
Smokes:
An insecticidal smoke can be released in the cavity occupied by the nest.
ADVICE
Valent BioSciences has an extensive range of products specifically formulated
for the control of flying
and crawling insect pests. Further information on all Valent BioSciences'
household insecticide products is available from:
Valent BioSciences Corporation
870 Technology Way
Suite 100
Libertyville, IL 60048
The greatest care has been taken to ensure the accuracy of the information
contained in this Fact Sheet. Under no circumstance, however, will Valent
BioSciences Corporation be liable in respect of any error or omission.
© Copyright Valent BioSciences Corporation 2001
|